SPC Performance AL SHIMS 4X6.5X0.5 deg.(6)

These economical over-the-road heavy duty truck axle shims a re our lowest cost option. With average compression strength and hardness these shims are available in a large variety o f sizes and offer the technician a cost effective means to c orrect...

SPC Performance 1/4 deg. Sleeve for FORD

This sleeve will easily change Camber and/or Caster .25° on Ford F450 and F550 Super Duty trucks with Dana Super 60 solid axles. Use the (23239) zero-degree sleeve to determine the amount of change needed and install the correct degree sleeve. To split...

SPC Performance 3/4 deg. SLEEVE for FORD

This sleeve will easily change Camber and/or Caster 0.75° on Ford Heavy Duty trucks. These sleeves are designed for Ford F250 and F350 Super Duty truck applications. Use the (23229) zero-degree sleeve to determine the amount of change needed and install...

SPC Performance 2 deg. SLEEVE for FORD

This sleeve will easily change Camber and/or Caster 2.00° on Ford F450 and F550 Super Duty trucks with Dana Super 60 solid axles. Use the (23239) zero-degree sleeve to determine the amount of change needed and install the correct degree sleeve. To split...

SPC Performance CAMS (4) for FORD EXPLORER

This set of 4 cams allows for quick installation without having to remove the upper control arm bolt. Change camber and caster up to +-1.75deg. California Residents WARNING

SPC Performance 2.6 deg. Sleever for FORD SUPER DUTY

These sleeves have a fixed postive camber and caster change and are designed specifically to align trucks that have been lifted or to provide more caster change than our standard 23220 series. For maximum drivability and to compensate for road crown, use...

SPC Performance 3-1/4° CAMBER/CASTER SLEEVE

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to...

SPC Performance 1-1/2° FORD CAM/CAS SLEEVE

This sleeve will easily change Camber and/or Caster 1.50° for vehicles equipped with twin traction beam DANA 44 axles. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve...

SPC Performance 1/2 deg. 4X4 BUSHING for 69-74 Chevy Blazer

This sleeve will easily change Camber and/or Caster .50° for vehicles equipped with DANA 44 or GM 10 bolt axles. Installation requires removal of the upper ball joint stud nut. Break the taper free between the stud and sleeve, determine the change needed...

SPC Performance MAGNET FOR 81139 GAUGE

Part #81133 replaces the magnet portion of the Adjustable Magnetic Camber Gauge #81139. Includes one replacement magnet.#81134 - Replacement Vial Bubble

SPC Performance 2 deg. CAMBER/CASTER Sleeve

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Use 77880 or 88830 sleeve puller to...

SPC Performance ROUND BRG RECVR 1.1875in.

Bearing Dia 1.1875",Bearing Race Width 0.5670", Receiver OD 1.483",Receiver Height 0.84" Bearing Offset 0.0265". California Residents WARNING